Other products by Qolsys
(Tech Support Website)

Item #: QS7134840
MSRP: No Retail



The IQ Hardwire 16-F offers a cost effective way of integrating hardwired security & smoke detector zones with the IQ Panel 2. It includes a large enclosure with ample wire routing room, backup battery charging, 500mA of 12volt auxiliary power, an onboard siren relay, built-in status LED’s for each zone and support for up to 10 two-wire smoke detectors. Normally Open and Normally Closed contacts are supported as well as powered zones like motion sensors and glass break detectors. Note: Not for use with CO detectors


Input Voltage: 16.0VDC Plug-In Transformer Backup Battery: 12VDC 5AH Max (not included) Dimensions: 16” X 14” X 3” Operating Temperature: 32 to 122F (0 to 50C) EOL Supervision: 4.7k Ohm fixed or 1k-10k Ohm depending on Resistor Mode Input Zones: 15 N/O or N/C Smoke Zone: 1 two-wire smoke loop, 10 detectors max. Support for System SensorĀ® 2W-B, 2WT-B, 2WTA-B* *Detector models should not be mixed Auxiliary Voltage Output: 12VDC @ 500mA Max Tamper Zone: Used for case tamper, no resistor Relay Contact: 60VDC/1A Max drives siren


Compatible Control Panel: The IQ Hardwire 16-F is for use with the Qolsys IQ Panel 2 only. Refer to the full IQ Panel 2 installation manual for typical installation layout, including recommended locations of the control unit, detectors and notification appliances. Enclosure: For UL Installations, Qolsys enclosure QR0073-840 shall be used. Listed Resistor: For UL Installations, Qolsys 4.7K Fire Resistor Part # QR0072-840 shall be used on the 2-wire fire loop at the end of line. Wiring: For UL Installations, recognized limited energy cable shall be used.



Enclosure Quick Guide

Prop 65WARNING: This product contains chemicals including Styrene which is known to the state of California to cause cancer, and Bisphenol A (BPA), which is known to the state of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

New Project

Print Project