Single Channel HD Video, Data Transmitter & Receiver & Power (12V/24V DC/AC), 5.9" Pigtails

Video, power & data transmitter and receiver that allows the transmission of real ‐ time CCTV HD video, power and data signal via cost ‐ effective Unshielded Twisted Paired (UTP) cable. Baseband (composite) signals of any type are supported. The 95-1052 is compatible with all HD ‐ TVI, HD ‐ CVI and AHD analog cameras. Used in pairs, the 95-1052 eliminates costly and bulky coaxial cable. The superior interference rejection and low emissions of the 95-1052 allow video signals to coexist in the same wire bundle as telephone, datacom, or low ‐ voltage power circuits, providing access to shared or pre-existing cables. The 95-1053 has a built ‐ in surge suppressor to protect video equipment against damaging voltage spikes. The built-in circuitry provides against crosstalk and noise immunity to ensure the highest quality video signals. (sold in Pairs).

Specifications:

• UTP Termination: RJ45 Jack (8 Pin)
  
• Cables:Male BNC plug, Data (RS485, RS422) pigtail, 2.1mm Coax Power Plug, length 5.9"
  
• Video Termination: 75 Ohm Male BNC connector
  
• Video Formats: HD-TVI, HD-CVI, AHD-Analog Signals
  
• Video Standards: NTSC, PAL & SECAM
  
• Signal Isolation: 60db Crosstalk and noise immunity
  
• Lightning Protection: Design Grade III
  
• Built-in TVS: (Transient Voltage Suppressor) for electrical surge protection
  
• Housing: ABS Plastic
  
• Size:Balun Body, L-2.37” x W-1.14” x H-.8