Jasco Z-Wave Dimmer Wall Switch

Control Dimmable Lighting Up to 600W

You can enable Z-Wave remote control for a dimmable wired lighting fixture by replacing your traditional switch with the Jasco Z-Wave Wireless Lighting Control Dimmer Switch. The switch supports lighting loads up to 600W. Once connected to the load, the switch can be used to dim/brighten and turn the load on/off locally or with a Z-Wave controller (sold separately).

• Supports incandescent, LED, and CFL lighting
• Replaces an existing light switch or used for new construction
• Supports advanced configuration, switch inversion
• Blue LED guides you to the switch in the dark
• LED can be enabled/disabled manually

Available Colors: White paddle installed. Light Almond paddle included.

Installation Details

The Z-Wave Wireless Lighting Control Dimmer Switch is suitable for single-pole or multi-pole configuration. Up to three auxiliary switches (sold separately) can be used in conjunction with this switch. This model can also be included in multiple zones/scenes.

The switch requires standard screw terminal installation with wiring connections for Line (Hot), Load, Neutral, and Ground. Multi-pole installation also requires a traveler wire. The switch features inline traveler circuit protection.

Note: Wallplate not included. Uses standard single-gang wallplate. For indoor use only. Not compatible with fluorescent, xenon, or halogen lights. Does not support motor loads.

Specifications

• Power: 120 VAC, 60 Hz
• Frequency: 908.42 MHz
• Minimum Load: 40W
• Maximum Load: 600W Incandescent; 150W Dimmable CFL/LED
• Range: Up to 100 feet line of sight between the Wireless Controller and the closest Z-Wave receiver module.
• Environmental Conditions: For indoor use only.
• Operating Temperature Range: 32 to 104° F (0 to 40° C)
• Approvals: UL, FCC, IC