Jasco Z-Wave On/Off Wall Switch

You can enable Z-Wave remote control for a wired lighting fixture or appliance by replacing your traditional switch with the Jasco Z-Wave Wireless Lighting Control Switch. The switch supports lighting loads up to 960W and resistive loads up to 1800W. Once connected to the load, the switch can be used to turn the load on/off locally or with a Z-Wave controller (sold separately).

• Supports incandescent, LED, CFL, xenon, halogen and fluorescent lighting
• Replaces an existing light switch or used for new construction
• Supports advanced configuration, switch inversion
• Blue LED guides you to the switch in the dark
• LED can be enabled/disabled manually

Available Colors: White paddle installed. Light Almond paddle included.

Installation Details

The Z-Wave Wireless Lighting Control Switch is suitable for single-pole or multi-pole configuration. Up to three auxiliary switches (sold separately) can be used in conjunction with this switch. This model can also be included in multiple zones/scenes.

The switch requires standard screw terminal installation with wiring connections for Line (Hot), Load, Neutral, and Ground. Multi-pole installation also requires a traveler wire. The switch features inline traveler circuit protection.

Note: Wallplate not included. Uses standard single-gang wallplate. For indoor use only.

Specifications

• Power: 120 VAC, 60 Hz
• Frequency: 908.42 MHz
• Load Ratings:

• Incandescent: Min. Load: 40W; Max. Load: 960W
• Motor: 1/2HP
• Resistive: 1800W

• Range: Up to 100 feet line of sight between the Wireless Controller and the closest Z-Wave receiver module.
• Environmental Conditions: For indoor use only.
• Operating Temperature Range: 32 to 104° F (0 to 40° C)
• Approvals: FCC, IC