HDMIEXTEND Point-to-Point HDMI/CAT-5 Extender

The HDMIEXTEND extends your HDTV display up to 200 feet away from your HDTV source using two CAT-5 cables. It is equipped with HDMI™ (high definition multimedia interface) connectors and is capable of supporting DVI (digital visual interface) equipment when used with a HDMI to DVI Adapter, providing greater flexibility and options when integrating several home theater components.

HOW IT WORKS

The HDMIEXTEND transmitter unit sits next to your computer, set-top box or DVD player source. Cables supplied with the HDMIEXTEND connect your DVI or HDMI™ source to the transmitter unit. The HDMIEXTEND receiver unit sits next to your HDTV display - up to 200 feet away. The display plugs into the back of the HDMIEXTEND. The HDMIEXTEND system consists of: (1) HDMIEXTEND transmitter (1) HDMIEXTEND receiver (1) 6 ft HDMI to HDMI Cable M-M (2) HDMIEXTEND wall-mount adaptor plates (2) 5VDC power supply

INSTRUCTIONS 1) Connect your display to the HDMIEXTEND receiver unit 2) Connect your source to the HDMIEXTEND transmitter unit 3) Connect your CAT-5 cables between the transmitter and the receiver 4) Plug the 5V power supply into the HDMIEXTEND transmitter and receiver unit You should now have picture. If you do not see a picture, try unplugging and replugging the HDMI input on the HDMI sender unit. Make sure your CAT-5 cables are not crossover type and have been properly crimped and tested. Cycle the power on the unit. * If problems persist try adjusting the Dip Switches by following the Dip Switch Usage Guide.

OPERATION NOTES READ THESE NOTES BEFORE INSTALLING OR OPERATING THE HDMIEXTEND • The HDMIEXTEND transmitter and receiver is housed in a metal box for better RF shielding. • The CAT-5 cable should not exceed 200 feet. • If you do not need DDC or HDCP data you can use a single CAT-5 cable for the video only. The DDC will not be connected. (For further information, see our Technology Terminology section) If HDCP is required, both CAT-5 cables must be used between the transmitter and receiver units. • CAT6 cable is suitable for high resolutions at 50 meters. SERVICE SWITCH USAGE GUIDE The transmitter and receiver of the HDMIEXTEND products both contain a set of service switches (also called dip switches) located underneath each unit. Peeling back the silver sticker will reveal the service switch bay. These service switches are used to boost and equalize the signal to best match the conditions in your setup. (*Note: Adjustments should be done with sources and display on. Switches 3 and 4 are not used.)